AIM-120C AMRAAM  -  6 ft (1829 mm) display model, ~1:2 scale
Designed by CirusThaVirus

THANK YOU!
Thank you so much for downloading this model. I'm a stay-at-home dad building
a maker and product-review channel, and every download means a lot to me.
If you print it, I'd love to see it! Please post a video on TikTok and tag me:
@cirusthavirus.official
Happy printing!  -  CirusThaVirus

WHAT TO PRINT (30 parts: 28 + 2 optional saddles)
- 01-11  Nose tip, nose base, 9 body tubes ........ print 1 each
- 12     Coupler ................................. print 9 (all identical)
- 21-24  Wings ................................... print 1 each (4 total)
- 25-28  Tail fins ............................... print 1 each (4 total)
- 29-30  Display saddles ......................... optional
Every part fits a 256 x 256 mm bed and is 200 mm tall or less.

RECOMMENDED PLA SETTINGS (0.4 mm nozzle)
- Layer height: 0.20-0.24 mm
- Walls / perimeters: 4 (the tubes are 1.6 mm thick; 4 walls prints them as solid wall)
- Top layers: 4    Bottom layers: 3
- Infill: 5-10% (gyroid or adaptive cubic)
- Supports: NONE needed. The parts are designed support-free.
- Nozzle 205-215 C, bed 55-60 C
- Brim: 5 mm recommended on the nose tip and the tall tubes for adhesion
- Orientation: as exported. Tubes, couplers and nose upright; wings and fins flat side down.

ASSEMBLY
1. Push a coupler halfway into each tube socket, lining its slot up with the key rib.
2. Slide the next tube on. Work from the nose to the tail.
3. Glue the wing and fin tabs into their slots (CA glue or epoxy).
4. Optionally glue the couplers for a permanent build. Sand lightly if a fit is tight.

HANGING
Run fishing line or thin wire through the top lugs at 560 mm and 1530 mm,
one on each side of the balance point (~1000 mm from the nose). A third lug at
1050 mm is there as an optional extra hanging point. The assembled model weighs about 1.5 kg.

Static display model only.
